|
|
| (7 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | ==Introduction==
| + | [https://wiki.servarr.com/en/docker-arm-synology Moved to the new wiki] |
| − | Synology only offer a docker package on their <code>x64</code> based NAS. Using this method to install docker on an <code>aarch64</code> NAS is totally unsupported/untested and totally at your own risk. It is entirely possible it will destroy your NAS.
| |
| − | | |
| − | ==Installation==
| |
| − | | |
| − | Log in as <code>root</code> to your synology. Execute the following command:
| |
| − | | |
| − | curl https://gist.githubusercontent.com/ta264/2b7fb6e6466b109b9bf9b0a1d91ebedc/raw/7b11f25c3dce181faa5206aed8051f176cc4e406/get-docker.sh | sh
| |
| − | | |
| − | If all goes well you should see the message:
| |
| − | <pre>Done. Please add your user to the docker group in the Synology GUI and reboot your NAS.</pre>
| |
| − | | |
| − | Do as it says:
| |
| − | # Add your user to the new <code>docker</code> group using the Synology GUI
| |
| − | # '''Reboot.'''
| |
| − | | |
| − | Hopefully you have functioning <code>docker</code> and <code>docker-compose</code> commands, which should work when logged in as your normal user.
| |
| − | | |
| − | ==Caveats==
| |
| − | # It seems most ARM Synology don't support seccomp, so the docker container has unfettered access to your system (even more so than with a regular docker).
| |
| − | # Again, due to Synology constraints, all containers need to use <code>--network=host</code> (or <code>network: host</code> in compose) and everything will be directly accessible from the host. There are no port maps.
| |
| − | # Obviously you can only run aarch64 images, but most hotio and linuxserver images offer an aarch64 version.
| |
| − | | |
| − | ==Setting up Portainer==
| |
| − | If you want a GUI you can use the following example compose:
| |
| − | | |
| − | <pre>
| |
| − | version: '2'
| |
| − | | |
| − | services:
| |
| − | portainer:
| |
| − | image: portainer/portainer
| |
| − | restart: unless-stopped
| |
| − | network_mode: host
| |
| − | volumes:
| |
| − | - /var/run/docker.sock:/var/run/docker.sock
| |
| − | - portainer_data:/data
| |
| − | | |
| − | volumes:
| |
| − | portainer_data:
| |
| − | </pre>
| |
| − | | |
| − | Place this in an empty directory and call it <code>docker-compose.yml</code>. Run:
| |
| − | docker-compose up -d
| |
| − | And visit <code>http://ip:9000</code> to complete setup (where <code>ip</code> is the IP address of your synology).
| |
| − | | |
| − | For guidance setting up Sonarr/Radarr/Lidarr/Readarr, see the [[Docker Guide]], and '''remember caveat 2 above.'''
| |
